Deltor HPLL
This structure is the result of the experience gained both on mechanical engraving and on anti-wear coatings used in the gas and oil fields and also for corrugated cardboard.
The same manufacturing process of Deltor T is used, but the galvanic chrome-plating of the roll is replaced by coatings with anti-wear properties.
This specific product is mainly used in those applications where the kind of screen does not allow the use of laser beams (screens from 5 to 20 l/cm).
The possible configurations are listed in the technical data sheets for mechanical engravings.
Mechanical properties
Micro-hardness (HV 300) 1100_1200 HV
Roughness after lapping 0.2 Ra
Porosity < 1%
Bond strength > 60 MPa
| Limits | |
| Minimum roller diameter | 100 mm |
| Maximum roller diameter | 1000 mm |
| Minimum table length | 300 mm |
| Maximum table length | 6000 mm |
| Engraving limits | above 30 l/cm |
Gallery of Deltor engraving configurations
Incisione 01
Incisione 02
Incisione 03
Incisione 04
Incisione 05
Incisione 06
Refurbishment service
Quotation request
Engravings available
Contacts
Simec Group Srl
Deltor Division
Tel: +39 0331 393900
Fax: +39 0331 323382
Email: deltor@simecgroup.com
Certificate
